Piper AD Placard – Do Not Open the Throttle Rapidly
$8.00
This Do Not Open the Throttle Rapidly placard reproduces the AD-required cockpit warning — “Do not open the throttle rapidly (idle to full throttle in 2 seconds minimum)” — in white on black.
Do Not Open the Throttle Rapidly Placard
The Do Not Open the Throttle Rapidly Placard reproduces the throttle-operation warning required on certain Piper aircraft: “Do not open the throttle rapidly. (Idle to full throttle in 2 seconds minimum.)”
Placard text
DO NOT OPEN THE THROTTLE RAPIDLY.
(IDLE TO FULL THROTTLE IN 2 SECONDS MINIMUM.)
Compatibility
This Do Not Open the Throttle Rapidly Placard is required on certain Piper models by Airworthiness Directive; whether it applies to your aircraft, and the exact wording, depend on your model, serial number, and the applicable AD.
This placard reproduces the wording shown. Your aircraft’s POH/AFM, its type certificate data sheet, and any applicable Airworthiness Directives are the final authority on the exact placard and wording required — confirm these for your model and serial number before ordering. If you need different wording, please contact us.
Materials & installation
- Thermally printed on 3M Scotchcal 220 high-performance cast vinyl, rated for years of service (−40°F to 225°F).
- Sealed with a Lexan over-laminate for a tough, scratch- and abrasion-resistant cockpit finish that stays clear and legible.
- Pre-cut with a peel-and-stick pressure sensitive adhesive — clean the surface, peel the backing, and press it into place. No trimming required.
Frequently asked questions
Is the Do Not Open the Throttle Rapidly Placard a direct replacement?
The Do Not Open the Throttle Rapidly Placard reproduces the original markings so it drops straight in as a clean, legible refresh. Always compare it to your existing item and confirm the details against your POH/AFM before installing.
Can you change the wording?
Yes. If your required text differs, contact us with the exact wording and we will print it to match.
How is it installed?
It is pre-cut with a peel-and-stick pressure sensitive adhesive. Clean the surface, peel the backing, and press it into place — no trimming required.
Reviews
Product reviews are on the way — we’re setting up reviews for individual placards.
In the meantime, see what Piper owners say about our placards and our service on our Testimonials page, and across the Piper owner forums and community groups where customers share their experience.